Are you looking for one of the best and most exclusive absorbers on the market? NeoFlex is both of these. The only magnetic absorber for the optimal set up of your hi-fi device. Its design is based on the principle of magnetic repulsion. Two extremely powerful Neodym magnets hold the weight of the hi-fi device. In this way the NeoFlex absorber separates the device from the floor. Its design and high mass make the NeoFlex an ideal instrument to optimize your high end system. Energy is transferred from the device and destroyed in the absorber. Since NeoFlex absorbers are raised, at least four absorbers can be used. Depending on the different models, absorber can take a load capacity of 1.2 – 8kg. Four absorbers can therefore bear a weight of up to 32 kg. The NeoFlex absorber has a magnet cap, so they can place under each high end devices.
Material: Aluminium body, special metal cap for no magnetic flux leakage, Teflon rings, stainless steel platform, adjustable height
With the central screw under the absorber, the (right) groove can be adjusted. By using this screw the lower Neodym magnet can be set. If you bring the magnets closer together you can increase the absorber’s load capacity. As with the Lyd absorber, the device can be disconnected with the upper damping ring and it can be connected without the ring. With the outer damping ring the absorber’s effect is magnified. Try the absorber with the damping ring on the device as well as on the surface itself. The outer damping ring is for vibration minimizing. In this way it is possible to further optimize the absorbers.
Please make note of the following when working with Neodym magnets:
The magnets should not be used near pacemakers, magnetic data storage devices and monitors. Take care not to pinch your skin with the magnets. Do not allow the magnets to smash together as this can cause them to chip. We are not liable for any damage that results from improper use of the magnets. The NeoFlex absorber has a magnet cap, so they can place under each high end devices.